CNC Fork and Caliper Set, Jog 50


CNC Fork and Caliper Set, Jog 50

Your Price $300.00
Price plus sales tax, plus delivery


Nice CNC forks and post mount caliper make your Jog based scooter or clone sharp!

This setup is so light! The 4 piston caliper weighs almost nothing!

CNC ends give your ride a jeweled look.

A better ride and killer looks! Use as is with a 200mm rotor or use spacers or a couple washers to run a 220mm rotor.

ATTENTION DUNDERHEADS!! THIS STUFF DOES NOT BOLT ON A RUCKUS. MAKE SURE YOU FIGURE THINGS OUT BEFORE YOU BUY IT..

LENGTH 13" FROM TOP TO AXLE BOLT CENTER

TUBE AT CLAMPING AREA IS 26MM

AXLE HOLE IS 10MM

Comes as shown with caliper hardware and trick banjo bolt.

Browse this category: Closeout Items